Search results for "Soil physical quality"

Comparing Physical Quality of Forest and Pasture Soils in a Sicilian Watershed

2011

Forest and pasture soils should have differing properties due, for example, to differing root characteristics or livestock trampling rates, but contradictory results are reported in the literature. The surface soil physical and hydraulic properties of five forest and pasture sites were determined in a Sicilian watershed. In general, forest soils had a significantly lower bulk density, b (by 17 to 35%), and a higher field saturated hydraulic conductivity, Kfs (by a factor of 3.4-11.5) than pasture soils. Differences between water retention characteristics of forest and pasture soils were low when high levels of organic matter, OM, content (> 7.1%) were detected for both land uses. The mean …

Comparing different methods to determine soil physical quality in a mediterranean forest and pasture land

2016

Soil physical quality (SPQ) can be assessed by different experimental methodologies and criteria and the optimal/critical values or ranges for SPQ indicators are still approximate. Sampling soils with minimal anthropic pressures should allow improvements in SPQ assessment. Different experimental methodologies and criteria were applied to sample a Mediterranean oak forest (Quercus ilex L.) and pasture land, in Sicily, with a varying degree of anthropic disturbance. Soil water retention was determined in the laboratory and the field, using the BEST (Beerkan Estimation of Soil Transfer parameters) procedure of soil hydraulic characterization. Capacity-based indicators, the S index, and locatio…

The Mechanical Impact of Water Affected the Soil Physical Quality of a Loam Soil under Minimum Tillage and No-Tillage: An Assessment Using Beerkan Mu…

2021

The multi-height (low, L = 3 cm

Testing different approaches to characterize Burundian soils by the best procedure

2011

Abstract The Beerkan Estimation of Soil Transfer parameters (BEST) procedure seems attractive for soil hydraulic characterization but it has received little testing so far. The objective of this investigation was to test BEST with different application approaches for some soils in Burundi, where there is the need of using simple methods to characterize soils. Most (14) of the 19 sampled sites had a clay soil texture whereas texture ranged from silty clay to loam in the other cases. On average, the fitting ability of both the particle size distribution (PSD) model (mean relative error, Me ( E r ) = 2.0%) and the cumulative infiltration model ( Me ( E r ) = 2.3%) was good according to recomme…

Use of BEST Procedure to Assess Soil Physical Quality in the Baratz Lake Catchment (Sardinia, Italy)

2016

Conversion of Mediterranean maquis and/or natural forest into agro-pastoral lands is a cause of soil degradation in many Mediterranean areas. Indicators of soil physical quality (SPQ) quantitatively linked to soil hydraulic properties are a valuable tool to assess the effect of land use changes. In this investigation, the Beerkan Estimation of Soil Transfer parameters (BEST) procedure for soil hydraulic characterization was used to estimate SPQ indicators. Four areas of the Baratz Lake watershed, Sardinia, Italy, characterized by both typical natural vegetation (holm oak [ Quercus ilex L.] forest and high maquis) and degraded vegetation (grassland established after fire or clearing of the m…

Evaluation of soil physical quality under different soil land uses in a small Sicilian watershed

2013

Sustainability of extensive rain fed agriculture needs assessment of land use effects on soil physical and hydraulic properties. Several soil physical quality indices were determined for four adjacent areas in a small Sicilian watershed, that were characterized by a different land use, namely cropland (C), olive grove (O), grassland (G) and eucalyptus plantation (E). Soil texture was similar for the considered areas, even if the no-tilled soils (G and E) showed a higher clay content in the top layer (0-20 cm) than in the lower layer (20-40 cm). The bulk density of the top layer ranged between 1.20-1.43 g cm-3 (C < G < O < E), with significant differences between C and E. In the lower layer,…

Soil physical quality in a Sicilian agricultural area

2008

Using static and dynamic indicators to evaluate soil physical quality in a Sicilian area

2016

Both capacitive indicators derived from the water retention curve and dynamic measurements of the flow-weighted mean pore radius, R0, were used to assess the soil physical quality of two agricultural areas (cropland and olive orchard) and two natural areas (grassland and managed woodlot plantation) potentially subject to soil degradation. The overall idea of the study was to investigate whether a dynamic indicator quantitatively derived from hydraulic conductivity measurements could be used to supplement the traditionally applied capacitive indicators retrieved from water retention measurements. According to the available criteria, only the surface layer of the cropland site showed optimal …